The 1/2-inch soffit panel system is mechanically attached and installed in a sequential pattern. All panel systems are to be roll formed to specified dimensions and tolerances and shall be accurately formed.
The 1/2-inch soffit panel system is mechanically attached and installed in a sequential pattern. All panel systems are to be roll formed to specified dimensions and tolerances and shall be accurately formed.
· 35-year warranty on coil-coated Kynar 500®/Hylar 5000®
· Male/female interlocking joint design
· Optional vented profile
· Sequential installation
· Lightweight
· Coil anodized aluminum
· Coil-coated aluminum (20-year warranty)
· Panel width 12″
· Post-painted aluminum skins (short run, custom colors) 0.063 to 0.125
· Batch anodized
· Coil-anodized
· Custom coatings
· Kynar 500®/Hylar 5000® high performance fluorocarbon resinous coatings
· Length restrictions apply
· Oil canning is not a cause for rejection
· Panel edges must be straight lines (no curves)
· Panels cannot be radiused
· Panels cannot be tapered
· Panels may exhibit out of plane behavior
· Panels may not be curved
• 35-year warranty on coil-coated Kynar 500®/Hylar 5000®
• Male/female interlocking joint design
• Optional vented profile
• Sequential installation
• Very lightweight